Placement of Seat Covers and Cleaning Instructions

Placing the cover on your recumbent bike seat.
You can leave on the original black cover if you like, however some covers may not fit properly.

• When your seat cover arrives, please make sure you read the supplied card attached, which has information regarding the seat cover and the website.
  
  If the seat is off the bike proceed with these instructions:
• Place seat cover on a flat surface with the toggle to the right  and with wrong side of fabric facing you.
• Place seat on the cover (toggles are either on the back or near the horn of the seat cover) and start to draw the cover around the seat to adjust to fit.
  
• If you have a Bacchetta Strada cover, then the toggle will be at the top of the seat.
• Cinch the toggle down towards the material and tuck in the excess cording under the material.


If the seat is on the bike:
• Place the cover so the toggle is on the right of the seat towards the back. (Sometimes the toggle will be higher/lower or near the horn).
• Bacchetta Strada toggles are suppose to be at the top of your seat. This allows for the Velcro (in the back of foam) not to be covered for a secure seat.
• Start to pull cording around sides, adjusting the cover around the entire seat.
• Cinch the toggle upwards towards the material and tuck in the excess cording under the material.

We would like to thank you for your purchase.
 We hope you tell your friends and check back often for new arrivals.

Cleaning instructions come with each cover. We only use two types of material:
Spandex hand wash in cold water. Hang Dry. NO HEAT!
Ripstop-Wipe with cool damp cloth. Hang Dry. NO HEAT!